Replacing a filler neck on a 2015 Ford Edge. As you can see from the picture below that there are two flaps where the gas nozzle goes into. The first flap has been taken off only showing the second flap, but a common issue is that if you insert the gas nozzle to hard it will break the inside flap causing a check engine light and a rough start after pumping gas. The reason for the check engine light to come on and the vehicle to run rough is that the vehicle doesn’t create the proper vacuum allowing too much air to get into the intake causing the vehicle to run lean. When a vehicle is running lean it means too much air is getting to the engine and not enough gas causing the vehicle to idol and drive rough. If you have any questions or would like to set up an appointment please call us at (410)-730-3839.
Check out these before and after photos of headlights. We will clean your lamp assemblies to like new condition.
Camping season is here!! Yes we service Rv's and boats too!!
2016 Jeep Wrangler in for a suspension lift, exhaust work, wheels, tires and other upgrades.
2007 f150 getting another chance at life with a jasper remanufactured engine. Installed at our shop in Columbia Maryland. The jasper engine comes with a transferable 3 year, 100,000 mile parts and labor warranty!!!
2011 Kia Sorento got stuck in snow and stripped the splines on the drive shaft where it goes into the transmission. If you get stuck, call for help.
Julie has her 2006 Jeep Wrangler in for smoke coming from the rear brakes. The brake calipers were not releasing fully causing the pads to drag on the rotors. As you can see, the pads and rotors got extremely hot. Lmt replaced the rear brakes and flushed out the system with fresh fluid.